setting up an encrypted home directory (on gentoo)

From thelinuxwiki
Revision as of 17:42, 12 April 2013 by Nighthawk (Talk | contribs)

Jump to: navigation, search

This procedure was performed using a newly added virtual hard drive (/dev/sdb) in a VM. Substitute your device and number where appropriate.


Identify my newly added drive (sbb)

mybox ~ # ls /dev/sd*
/dev/sda  /dev/sda1  /dev/sda2  /dev/sdb

Install a kernel with needed dev mapper / crypto support (steps not covered here). If you are using a distro other than gentoo then your kernel will most likely already have the needed support.

Install the cryptsetup package

mybox ~ # emerge -av --quiet cryptsetup

create a linux partition to encrypt

mybox ~ # fdisk /dev/sdb

mine looked like this...

Command (m for help): p
Device Boot Start End Blocks Id System /dev/sdb1 2048 41943039 20970496 83 Linux

encrypt the partition, set the passphrase (used to unlock it)

mybox ~ # cryptsetup -c aes-xts-plain -s 512 -v -y luksFormat /dev/sdb1

WARNING! ======== This will overwrite data on /dev/sdb1 irrevocably.
Are you sure? (Type uppercase yes): YES Enter LUKS passphrase: Verify passphrase: Command successful.

move your home directory. I did this on a running system without X11. If you are root, stop X, and drop to into one of the psuedo terminals, this should work for you just fine.

 mybox home # mv /home/ /home_backup/

open the encrypted partition and create dev mapper entry

   mybox home # cryptsetup luksOpen /dev/sdb1 home
   Enter passphrase for /dev/sdb1: 

make your filesystem

   mybox home # mkfs.ext4 /dev/mapper/home

now you can mount it :)

   mybox home # mount /dev/mapper/home /home

copy your saved home dir data to the new encrypted home partition

   mybox home # rsync -pav /home_backup/ /home/

configure you box to open the new home drive on boot. You will be prompted for the password set above on every boot.

   mybox home # vi /etc/conf.d/dmcrypt 

added lines...

   target=home
   source='/dev/sdb1'
   

configure dmcrypt service to load on boot

   mybox home # rc-update add dmcrypt boot
    * service dmcrypt added to runlevel boot

configure fstab to mount home on boot

    mybox home # vi /etc/fstab

added or alter home line...

    /dev/mapper/home    /home    ext4    noatime         0 0

All done! enjoy your new, secure computing environment.

mybox home # reboot